Clam Drill Auger Conversion Kit Combo

Clam's® ice auger conversion kit allows an angler to use an 18 volt cordless drill as the power to drill your holes. Extremely lightweight and portable, it has changed ice fishing forever.

The foks at Clam improved the design and added the ability to use your drill without taking the chuck off. It gets the same great results as the original design, but is more user-friendly. 

Results will vary depending on drill used. Using a high torque 18 volt lithium battery powered drill is recommended. Ball bearing absorbs the load from the auger so the drill is only used to spin the auger and not to support the auger torque, greatly extending the life of your drill. Attach your auger bit just like you normally would on a power auger.  No hassle, no worry setup, no loose bit falling out of the drill - just pull the trigger, drill and start fishing!

Conversion Kit - Model #9497

• Anodized aluminum frame, handle and plate
• Rubber dipped handles and trigger for easier handling and use
• Longer upright bracket to accommodate more drill types
• Lightweight and portable
• Tested by drilling through over 700" of ice (tested with Panasonic® 18 volt EY7450 drill)
• Works with most current 18 volt 1/2" drive cordless drills
• Hardware to mount drill included
• Weight: 5 lbs. (with auger bit / tested drill - 14 lbs.)

Auger Bit - Model #9498

• 6" auger bit with tempered stainless steel blades, steel flighting (replacement blades available)
• Handle to work as hand auger
• Extension kit compatible
• Weight: 5 lbs. (not including hand auger handle)